![]() ![]() Simpler pages, consisting mostly of plain, black text and basic monochrome graphics, posted an aggregate speed of 10.3 pages per minute (ppm) on the PC and 9.7 ppm on the Mac. I would definitely take a long hard look at the feed tubing in the printer to see if there's now a worn in kink/fold in the tubing as that would inevitably cut flow to the printhead with each printhead pass and stress the printhead considerably.The output arrives quickly, too-again, the Expression XP-810 clocked some of the fastest times we’ve seen for a consumer-level inkjet. With a little luck that should resolve things. Once it's released gently push the cleaning solution into the printhead so you have a solution rather than air in the tube/nozzles then replace the cartridge. Keep repeating as last two steps required until you finally get a release of any holding pressure (ie: clog releasing) ![]() Avoid forcing it, but let the solution work from both sides of the clog for a couple of hours and repeat. Gently!! push and pull the solution through the system to try and loosen the clog connect the syringe to a suitable diameter tube that will snugly fit over the cartridge receiver nipple/stem Fill a syringe with a 10+ml of the small solution Refill the capping/cleaning station with your windex solution (ensure the printhead is located in the park position) The printer is not even a year old yet I hate to have to trash it and buy a new one. Is there anyway to take the print-head out clean the head if not does anyone have a fix for this? I also tried mikling's post on air bubbles in the "feed tube" of Epson 710 I bought a head cleaning kit that had new cartridges and reset chips with cleaning fluid.įor the last week I have use Windex in the capping station and let it soak over night. I have tried many different things to fix the problem but none have worked. I cleaned it out and refilled it but it was to late. ![]() I am almost sure that it is clogged I use a ciss and have for years on other Epson printers.Ībout a 2 months ago the yellow ink tube got pinched and stopped the flow of ink the ink dried in the cartridges before I found it. I am also having a problem with my yellow ink not printing. Is there any way to reset the error message? I downloaded a reset-er program and when I ran the program it tells me that that I don't need to reset the counter, but every time I turn on the printer I still get the ink pad message. ![]() I have had a wast ink bottle system on my Artisan 810 scene it was new so it's not full. I am getting "the printer's ink pads are nearing the end of their life." message. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |